Wincor Nixdorf BEETLE AT COM Board Uživatelský manuál stáhnout pdf (Strana 44)

38 BEETLE /M-II plus (BOS) User Manual

Starting Up the System

After installing the BEETLE /M-II plus (BOS), switch on the system by using

the ON/OFF button on the front panel and the power switch on the power

supply.

The system first performs an automatic self-test to test its basic functions.

For example, you may see the following message (irrespective of processor

type) on the monitor:

WN „ID xx/xx Date“

xx/xx is the placeholder of the BIOS version number.

The system then determines the medium from which the operating system

and the application are to be booted. Each medium is assigned a logical

drive according to the configuration of your BEETLE /M-II plus.

The following media can be assigned a drive:

 Network

 Hard disk drive/solid state drive

 USB drive

The logical drives are designated C: and D:.

The network is always assigned to the C: drive during the runup procedure.

The hard disk can be assigned to the C: or D: drive. The system can only be

started from the hard disk if the disk has been configured as the C: drive.

Corresponding to the Setup configuration the modular BEETLE /M-II plus

(BOS) can be booted from the following drives:

 Hard disk drive C:

 LAN module with BOOTPROM

 USB drive

Please mind that the storage medium must be system-boot-capable.

If the operating system has started up without error, the application software

is automatically booted if necessary.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Žádné komentáře

Wincor Nixdorf BEETLE AT COM Board Uživatelský manuál Strana 44